Murray YARD KING EYK15540GF Lawn Mower Manual

The Murray YARD KING EYK15540GF is a 155cc gas-powered push lawn mower featuring a 40-inch cutting deck, 3-in-1 mulching/bagging/side-discharge capability, 6-position height adjustment, Briggs & Stratton engine with easy-start system, durable steel deck, large rear wheels for maneuverability, ergonomic handle with controls, and washout port for easy cleaning. Below are key sections for safety, features, assembly, operation, maintenance, and troubleshooting.

1. Features at a Glance 2. Assembly Instructions 3. Safety Precautions 4. Specifications 5. Controls and Operation 6. Cutting Height Adjustment 7. 3-in-1 Discharge System 8. Maintenance Schedule 9. Storage Guidelines 10. Warranty Information 11. Troubleshooting

Features at a Glance

Key components: Briggs & Stratton 155cc engine, 40-inch steel cutting deck, 3-in-1 discharge system, 6-position height adjustment, washout port, ergonomic handle with controls.

FeatureDescription
EngineBriggs & Stratton 155cc, 4-cycle, easy-start system
Cutting Width40-inch steel deck for efficient mowing
Cutting Height6-position adjustment (1.5-4 inches)
Discharge System3-in-1: Mulch, Bag, Side-discharge
WheelsLarge rear wheels for easy maneuverability
HandleErgonomic design with adjustable height
Washout PortFor easy deck cleaning after use
Fuel Tank1.0-gallon capacity
StarterRecoil start system
Blade TypeHigh-lift steel blade for optimal grass lift

Assembly Instructions

Unpack and inspect all parts. Assembly requires basic tools (included).

  1. Attach handle: Secure upper and lower handle sections with provided bolts.
  2. Install wheels: Attach all four wheels to axles using washers and retaining clips.
  3. Connect control cables: Route throttle and blade control cables along handle.
  4. Install discharge chute: Attach side-discharge chute if using side-discharge mode.
  5. Add engine oil: Fill with SAE 30 detergent oil (check dipstick for level).
  6. Add gasoline: Use fresh unleaded gasoline (87 octane minimum).

WARNING! Wear gloves during assembly. Ensure all bolts are tightened securely before operation.

Safety Precautions

Always follow safety guidelines to prevent injury.

  1. Read manual thoroughly before operation.
  2. Wear protective equipment: safety glasses, long pants, sturdy shoes.
  3. Clear mowing area of debris, rocks, and toys.
  4. Never operate without proper guards or discharge chute in place.
  5. Stop engine and disconnect spark plug before maintenance.
  6. Do not mow on steep slopes (over 15 degrees).
  7. Keep children and pets away during operation.

CAUTION! Gasoline is flammable. Refuel outdoors with engine off and cool.

Specifications

Controls and Operation

Handle controls: Throttle lever, Blade engagement lever, Drive control bar (if self-propelled model).

Starting Procedure:

  1. Check oil and fuel levels.
  2. Prime engine (3-5 presses on primer bulb).
  3. Set throttle to FAST position.
  4. Pull recoil starter firmly until engine starts.
  5. Allow engine to warm up for 30 seconds.

Stopping: Release blade control, move throttle to STOP, wait for blade to stop completely.

Cutting Height Adjustment

Adjust all four wheels simultaneously for even cutting.

  1. Stop engine and ensure blade is disengaged.
  2. Locate height adjustment lever near each wheel.
  3. Move lever to desired position (1=lowest, 6=highest).
  4. Ensure all wheels are set to same position.
  5. Test mow small area to verify height.

Tip: For first mow of season, set to highest position and gradually lower.

3-in-1 Discharge System

Configure for mulching, bagging, or side-discharge.

  1. Mulching: Install mulch plug; blade converts clippings to fine particles.
  2. Bagging: Attach grass bag to rear bracket; ensure bag is empty before mowing.
  3. Side-discharge: Install discharge chute; direct clippings away from work area.

WARNING! Always stop engine before changing discharge configuration.

Maintenance Schedule

Regular maintenance ensures optimal performance and longevity.

MaintenanceFrequency
Check engine oil levelBefore each use
Clean under deckAfter each use
Sharpen/replace bladeEvery 25 hours or when dull
Change engine oilFirst 5 hours, then every 50 hours
Replace air filterEvery 25 hours or as needed
Replace spark plugEvery 100 hours or annually
Check tire pressureMonthly

Storage Guidelines

Proper storage prevents damage and extends mower life.

  1. Clean thoroughly: Remove grass clippings from deck and undercarriage.
  2. Drain or stabilize fuel: For long-term storage, add fuel stabilizer or drain tank.
  3. Change oil: Fresh oil prevents corrosion during storage.
  4. Remove spark plug: Add teaspoon of oil to cylinder and pull starter slowly.
  5. Store in dry, covered area away from moisture.

CAUTION! Never store mower with fuel in tank near open flames or heat sources.

Warranty Information

Murray YARD KING EYK15540GF comes with a 2-year limited warranty covering defects in materials and workmanship. Warranty does not cover normal wear, misuse, or lack of maintenance. For warranty claims, contact Murray customer service at 1-800-800-7310 or visit www.murray.com. Keep original receipt as proof of purchase.

Troubleshooting

SymptomPossible CauseCorrective Action
Engine won't startNo fuel, old gas, clogged filterCheck fuel level; use fresh gas; clean/replace air filter.
Poor cutting performanceDull blade, low engine speedSharpen/replace blade; set throttle to FAST.
Uneven cuttingUneven tire pressure, worn bladeCheck tire pressure; balance or replace blade.
Excessive vibrationLoose blade, debris under deckTighten blade bolt; clean under deck.
Grass not dischargingWet grass, clogged deckMow when grass is dry; clean discharge area.
Engine stalls frequentlyDirty carburetor, old fuelClean carburetor; use fuel stabilizer.

Service: For technical support, call 1-800-800-7310 or visit www.murray.com

Murray YARD KING EYK15540GF Lawn Mower Manual © - All Rights Reserved 2025