Murray Parklander2690999 Lawn Mower Manual

The Murray Parklander2690999 is a 6.75 HP, 22-inch push lawn mower featuring a Briggs & Stratton engine, 3-in-1 discharge system (mulch/bag/side-discharge), single-lever height adjustment, durable steel deck, and easy-start technology. Below are key sections for safety, features, assembly, operation, maintenance, and troubleshooting.

1. Features at a Glance 2. Assembly Instructions 3. First-Time Setup 4. Specifications 5. Controls and Operation 6. Cutting Height Adjustment 7. Maintenance Schedule 8. Storage Guidelines 10. Safety Information 11. Warranty & Support 12. Troubleshooting

Features at a Glance

Key components: Briggs & Stratton engine, 22-inch steel cutting deck, 3-in-1 discharge system, single-lever height adjustment, rear bagger, and easy-start pull cord.

Feature	Description
Engine	6.75 HP Briggs & Stratton 4-cycle engine
Cutting Width	22 inches
Cutting Height	1.5 to 4 inches (6 positions)
Discharge System	3-in-1 (Mulch, Bag, Side-Discharge)
Deck Material	Durable powder-coated steel
Wheels	8-inch rear, 7-inch front
Starting System	Recoil pull-start
Fuel Tank Capacity	1.1 quarts
Weight	Approximately 65 lbs
Warranty	2-year limited warranty

Assembly Instructions

Unpack and inspect all parts. Assembly requires basic tools (included).

Attach handle: Align lower handle with deck brackets, secure with bolts and wing nuts.
Install upper handle: Connect to lower handle, tighten knobs.
Attach grass bag: Hook bag frame onto rear discharge chute.
Install side-discharge chute: If using side-discharge, attach to deck opening.
Add engine oil: Fill with SAE 30 detergent oil (check dipstick).
Add gasoline: Use fresh unleaded gasoline (87 octane minimum).

WARNING! Keep hands and feet clear of cutting blade during assembly. Ensure all fasteners are tight.

First-Time Setup

Before first use, complete final checks and adjustments.

Check oil level: Ensure oil is at full mark on dipstick.
Check tire pressure: Inflate to 20 PSI (front and rear).
Adjust cutting height: Set single lever to desired position (middle setting recommended).
Test start: Pull recoil starter slowly until resistance is felt, then pull briskly.
Engage blade control: Hold safety handle against handlebar, pull drive control lever.

CAUTION! Operate only in well-ventilated areas. Keep children and pets away during operation.

Specifications

Model: Parklander2690999
Engine: Briggs & Stratton 6.75 HP, 4-cycle
Cutting Width: 22 inches
Cutting Height Range: 1.5 - 4 inches (6 positions)
Deck: 22-inch steel, powder-coated
Discharge Options: Mulch, Bag, Side-Discharge
Wheels: 8-inch rear, 7-inch front
Fuel Type: Unleaded gasoline (87 octane minimum)
Oil Type: SAE 30 detergent oil (20 oz capacity)
Weight: 65 lbs (approx.)

Controls and Operation

Main controls located on handle: Blade control lever, drive control lever, height adjustment lever.

Starting Procedure:

Check oil and fuel levels.
Move throttle control to FAST position.
Prime engine (if equipped) by pressing primer bulb 3 times.
Hold blade control lever against handlebar.
Pull recoil starter briskly.

Stopping Procedure: Release blade control lever. Move throttle to STOP position.

Operating Tips: Mow when grass is dry. Overlap passes by 2-3 inches. Change mowing pattern weekly.

Cutting Height Adjustment

Single-lever adjustment controls all four wheels simultaneously.

Stop engine and wait for blade to stop completely.
Pull height adjustment lever toward wheel.
Move lever to desired position (1-6, with 1 being lowest).
Release lever to lock in position.

Recommended Settings: 2.5-3 inches for most grasses. Raise height during hot/dry conditions.

Maintenance Schedule

Interval	Task
Before each use	Check oil level, tire pressure, blade condition
Every 25 hours	Change engine oil, clean air filter
Every 50 hours	Replace spark plug, sharpen blade
Season end	Drain fuel, clean deck, lubricate wheels
Season start	Change oil, check all fasteners

Blade Sharpening: Remove spark plug wire. Remove blade. Sharpen at original angle. Balance before reinstalling.

Storage Guidelines

Proper storage extends mower life.

Drain fuel tank or add fuel stabilizer.
Run engine until it stops to clear carburetor.
Change oil if due.
Clean underside of deck thoroughly.
Store in dry, covered area.
Remove spark plug and add 1 tablespoon of oil to cylinder.

CAUTION! Never store with gasoline in tank for more than 30 days without stabilizer.

Safety Information

WARNING! Read all instructions before operating.

Always wear eye protection and sturdy shoes.
Clear mowing area of stones, sticks, and debris.
Never mow wet grass.
Disconnect spark plug before performing maintenance.
Keep hands and feet away from rotating parts.
Do not allow children to operate mower.
Always push mower forward; never pull backward.
Use extreme caution on slopes; mow across slopes, not up and down.

Warranty & Support

2-year limited warranty covering defects in materials and workmanship. Warranty does not cover normal wear, misuse, or lack of maintenance.

Customer Support: For parts and service, contact Murray Customer Service at 1-800-XXX-XXXX or visit www.murray.com. Have model number (Parklander2690999) and serial number ready.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Engine won't start	No fuel, old gasoline, clogged fuel line	Add fresh gasoline, clean fuel line, check spark plug
Engine runs poorly	Dirty air filter, old oil	Clean/replace air filter, change oil
Uneven cutting	Dull blade, uneven tire pressure	Sharpen blade, inflate tires evenly
Vibration	Loose blade, bent blade	Tighten blade bolts, replace bent blade
Won't self-propel	Drive belt loose or broken	Adjust or replace drive belt
Grass not discharging	Wet grass, clogged deck	Mow when dry, clean deck underside

For Service: 1-800-XXX-XXXX; www.murray.com