Murray Parklander2690998 Lawn Mower Manual

The Murray Parklander2690998 is a 26-inch walk-behind self-propelled lawn mower featuring a 9.0 HP Briggs & Stratton engine, 3-in-1 cutting system (mulch/bag/side discharge), single-lever height adjustment, durable steel deck, rear-wheel drive, and easy-start technology. Below are key sections for safety, features, assembly, operation, maintenance, and troubleshooting.

Features at a Glance

Key components: 9.0 HP Briggs & Stratton engine, 26-inch steel cutting deck, 3-in-1 discharge system, single-lever height adjustment, rear-wheel drive system, easy-start primer bulb.

Assembly Instructions

Unpack and inspect all parts. Assembly requires basic tools (included).

1. Attach handle: Secure upper and lower handle sections with provided bolts.
2. Install wheels: Slide wheels onto axles, secure with retaining clips.
3. Attach discharge chute: Align with deck opening, secure with wing nut.
4. Install grass bag: Hook bag frame onto deck rear brackets.
5. Connect control cables: Route throttle and drive cables to engine.
6. Add oil and fuel: Fill engine with SAE 30 oil; add unleaded gasoline.

WARNING! Do not add fuel indoors or near ignition sources. Wear gloves during assembly.

First-Time Operation

Complete assembly and pre-operation checks before starting.

1. Check oil level: Ensure oil is at full mark on dipstick.
2. Add fuel: Use fresh unleaded gasoline (87 octane minimum).
3. Set cutting height: Adjust lever to desired position (start at 3 inches).
4. Select discharge mode: Install mulch plug, bag, or side discharge chute.
5. Start engine: Set throttle to fast, prime 3 times, pull starter cord.
6. Engage drive: Squeeze drive control lever to propel mower.

CAUTION! Clear mowing area of debris. Keep bystanders away during operation.

Specifications

• Model: Parklander2690998
• Engine: 9.0 HP Briggs & Stratton, 4-cycle
• Cutting Width: 26 inches
• Cutting Height: 1.5-4 inches (6 positions)
• Drive: Rear-wheel self-propelled
• Deck Material: Powder-coated steel
• Fuel Capacity: 1.0 gallon
• Oil Capacity: 20 oz (SAE 30)
• Weight: 85 lbs (assembled)
• Warranty: 2-year limited

Controls and Settings

Handle controls: Throttle lever, drive control lever, blade control lever, height adjustment lever.

Operation: Throttle (turtle/rabbit symbols), drive control (squeeze to engage), blade control (must be held for blade rotation), height adjustment (single lever, 6 positions).

Engine: Primer bulb (3 presses for cold start), choke (pull out for cold start), fuel valve (on/off). Cutting: Mulch plug (for recycling), bag (for collection), side discharge (for clearing).

Cutting System Setup

Configure for mulch, bag, or side discharge.

1. Mulching: Install mulch plug in discharge opening.
2. Bagging: Attach grass bag to rear brackets.
3. Side discharge: Install discharge chute, direct away from people.
4. Height adjustment: Set lever to appropriate cutting height.

Tip: For best results, mow when grass is dry. Overlap passes by 2 inches.

Maintenance Schedule

Regular maintenance ensures optimal performance and longevity.

1. Before each use: Check oil level, inspect blade for damage.
2. Every 25 hours: Change engine oil, clean air filter.
3. Every 50 hours: Replace spark plug, sharpen blade.
4. Every season: Lubricate wheel bearings, check drive belt.
5. Storage: Drain fuel or add stabilizer, clean underside of deck.

WARNING! Disconnect spark plug before performing any maintenance.

Safety Features

Operator presence control: Blade stops within 3 seconds if handle is released. Blade control lever: Must be held against handle to engage blade. Safety labels: Read and understand all warning labels.

Storage & Winterization

Prepare mower for extended storage (especially winter).

1. Drain fuel: Run engine until tank is empty, or add fuel stabilizer.
2. Change oil: Replace with fresh oil to prevent corrosion.
3. Remove spark plug: Add 1 tablespoon of oil to cylinder, pull starter slowly.
4. Clean deck: Remove grass clippings and debris.
5. Store indoors: Keep in dry, covered location.

CAUTION! Never store mower with fuel in tank in enclosed area.

Warranty Information

2-year limited warranty covering defects in materials/workmanship. Warranty does not cover normal wear, misuse, or lack of maintenance. Proof of purchase required. For warranty service, contact Murray customer service at 1-800-800-7310 or visit www.murray.com. Keep this manual for reference.

Troubleshooting

Reset: For safety system, ensure blade control lever is fully engaged.

Service: 1-800-800-7310; www.murray.com