Murray Parklander2690997 Lawn Mower Manual

The Murray Parklander2690997 is a 26-inch walk-behind self-propelled lawn mower featuring a 9.0 HP Briggs & Stratton engine, 3-in-1 mulching/bagging/side discharge capability, 6-position cutting height adjustment, single-lever height control, 21-inch rear discharge opening, durable steel deck, and easy-fold handle for storage. Below are key sections for safety, features, assembly, operation, maintenance, and troubleshooting.

1. Features at a Glance 2. Assembly Instructions 3. First-Time Setup 4. Specifications 5. Controls and Operation 6. Cutting & Discharge Options 7. Maintenance Schedule 8. Storage Guidelines 10. Safety Information 11. Warranty & Support 12. Troubleshooting

Features at a Glance

Key components: 9.0 HP Briggs & Stratton engine, 26-inch steel cutting deck, Self-propelled drive system, 3-in-1 capability, Single-lever height adjustment, Rear bagger, Fold-down handle.

FeatureDescription
Engine9.0 HP Briggs & Stratton 190cc 4-cycle engine
Cutting Width26 inches
Cutting Height6 positions (1.5" to 4.0")
Drive SystemSelf-propelled rear-wheel drive
Discharge OptionsMulch, Bag, Side discharge
Deck MaterialDurable powder-coated steel
HandleEasy-fold design for compact storage
Wheels10-inch rear, 8-inch front
Fuel Tank1.0 gallon capacity
StarterRecoil pull-start

Assembly Instructions

Unpack and inspect all parts. Assembly requires basic tools (included).

  1. Attach handle: Insert lower handle into deck brackets, secure with provided bolts.
  2. Install upper handle: Connect to lower handle, secure knobs.
  3. Attach grass bag: Hook bag frame onto rear deck brackets.
  4. Install side discharge chute: Attach to discharge opening with wing nut.
  5. Add engine oil: Fill with SAE 30 detergent oil (20 oz).
  6. Add gasoline: Use fresh unleaded gasoline (87 octane minimum).

WARNING! Always wear gloves during assembly. Ensure all bolts are tightened securely.

First-Time Setup

Before first use, complete these steps.

  1. Check oil level: Ensure oil is at full mark on dipstick.
  2. Adjust cutting height: Set lever to desired position (middle setting recommended).
  3. Test controls: Verify drive control engages/disengages smoothly.
  4. Test safety features: Ensure blade control lever must be held to keep engine running.
  5. Break-in period: Operate at half throttle for first hour of use.

CAUTION! Never operate without proper oil level. Keep hands and feet away from cutting deck.

Specifications

Controls and Operation

Main controls located on handle.

Handle Controls: Blade control lever (must be held), Drive control lever, Height adjustment lever, Throttle control, Choke control.

Starting Procedure: 1. Move throttle to FAST position. 2. Pull choke knob out (cold engine). 3. Pull starter rope briskly. 4. Push choke in after engine starts. Stopping: Release blade control lever. Self-Propelled Operation: Squeeze drive control lever to handle to engage drive. Height Adjustment: Move single lever to desired position (1-6).

Cutting & Discharge Options

Configure for mulching, bagging, or side discharge.

  1. Mulching: Install mulch plug in discharge opening.
  2. Bagging: Attach grass bag to rear brackets.
  3. Side Discharge: Install discharge chute with wing nut.
  4. Height Selection: Adjust based on grass type/condition.

Tip: For best mulching, cut dry grass at proper height. Empty bag when ¾ full.

Maintenance Schedule

Regular maintenance ensures optimal performance.

  1. Before each use: Check oil level, inspect blade for damage, clear deck of debris.
  2. Every 25 hours: Change engine oil, clean/replace air filter, check spark plug.
  3. Every 50 hours: Sharpen or replace blade, check drive belt tension.
  4. Seasonal: Drain fuel before storage, lubricate wheel bearings, inspect cables.

WARNING! Always disconnect spark plug wire before performing maintenance. Allow engine to cool.

Storage Guidelines

Prepare mower for off-season storage.

  1. Drain fuel: Run engine until tank is empty, or add fuel stabilizer.
  2. Change oil: Replace with fresh oil.
  3. 3. Clean: Remove all grass/debris from deck and underside.
  4. Remove spark plug: Add 1 tablespoon oil to cylinder, pull starter slowly.
  5. Store: Keep in dry, covered area. Fold handle down for compact storage.

CAUTION! Gasoline left in tank can deteriorate and damage engine components.

Safety Information

Read and follow all safety instructions.

Warranty & Support

Murray offers a 2-year limited warranty for residential use. Warranty covers defects in materials/workmanship. Not covered: normal wear, misuse, lack of maintenance. For support, visit www.murray.com or contact 1-800-800-7310. Have model number (Parklander2690997) ready.

Troubleshooting

SymptomPossible CauseCorrective Action
Engine won't startNo fuel, bad spark plug, clogged air filterCheck fuel level; inspect/replace spark plug; clean air filter.
Engine runs poorlyDirty carburetor, old gasolineClean carburetor; drain and replace with fresh fuel.
Uneven cuttingDull blade, uneven tire pressureSharpen or replace blade; inflate tires to 15 PSI.
Loss of powerClogged deck, drive belt slippingClean underside of deck; adjust/replace drive belt.
Self-propel not workingDrive cable loose, worn drive beltAdjust drive cable tension; replace drive belt.

Service: For repairs, contact authorized Murray service center. 1-800-800-7310; www.murray.com

Murray Parklander2690997 Lawn Mower Manual © - All Rights Reserved 2025