Murray Parklander 2690998 Lawn Mower Manual

The Murray Parklander 2690998 is a 6.5 HP, 21-inch push lawn mower featuring a Briggs & Stratton engine, 3-in-1 side discharge/mulch/bagging capability, single-lever height adjustment, durable steel deck, and easy-start system. Below are key sections for safety, features, assembly, operation, maintenance, and troubleshooting.

1. Features at a Glance 2. Assembly Instructions 3. First-Time Setup 4. Specifications 5. Controls and Operation 6. Cutting Height Adjustment 7. 3-in-1 Discharge System 8. Safety Features 9. Maintenance & Storage 10. Warranty Information 11. Troubleshooting

Features at a Glance

Key components: 6.5 HP Briggs & Stratton engine, 21-inch steel cutting deck, 3-in-1 discharge system, single-lever height adjustment, rear bagger, mulch plug, and easy-start system.

Feature	Description
Engine	6.5 HP Briggs & Stratton, 4-cycle, overhead valve
Cutting Width	21 inches
Cutting Deck	Durable steel construction
Discharge Options	Side discharge, mulching, rear bagging (3-in-1)
Height Adjustment	Single-lever, 6 positions (1-3 inches)
Starting System	Recoil start with primer bulb
Wheels	8-inch rear, 7-inch front
Fuel Tank	1-quart capacity
Oil Type	SAE 30 (summer), 10W-30 (multi-season)
Handle	Foldable for storage

Assembly Instructions

Unpack and inspect all parts. Assembly requires basic tools (included).

Attach handle: Insert lower handle into deck brackets, secure with bolts and wing nuts.
Install wheels: Slide wheels onto axles, secure with push nuts or washers and cotter pins.
Attach bagger: Hook rear bagger onto deck mounts, ensure secure attachment.
Install mulch plug: For mulching, insert plug into discharge chute.
Add oil and fuel: Fill engine with SAE 30 oil (check dipstick). Add fresh unleaded gasoline.

WARNING! Wear gloves during assembly. Ensure all fasteners are tight before operation.

First-Time Setup

Before first use, complete pre-operation checks.

Check oil level: Ensure oil is at full mark on dipstick.
Add fuel: Use fresh unleaded gasoline (87 octane minimum). Do not overfill.
Inspect blade: Ensure cutting blade is sharp and securely fastened.
Adjust cutting height: Set lever to desired height (start at position 3).
Test start: Prime engine (3 presses), set choke, pull starter cord smoothly.

CAUTION! Operate outdoors only. Keep area clear of children and pets.

Specifications

Model: Parklander 2690998
Engine: 6.5 HP Briggs & Stratton, 4-cycle
Cutting Width: 21 inches
Cutting Heights: 6 positions, 1 to 3 inches
Deck Material: Steel
Discharge: Side, mulch, or bag (bag included)
Wheels: 8-inch rear, 7-inch front
Fuel Capacity: 1 quart
Oil Capacity: 20 oz (0.6 liters)
Weight: 55 lbs (approx.)

Controls and Operation

Main controls: Engine throttle, primer bulb, choke, recoil starter, blade control bar, height adjustment lever.

Starting: 1. Check oil and fuel. 2. Prime 3 times. 3. Set choke to "Start". 4. Pull starter cord firmly. 5. Move choke to "Run" after engine starts.

Stopping: Release blade control bar to stop blade. Move throttle to "Stop" to shut off engine.

Operation Tips: Mow when grass is dry. Overlap passes by 2 inches. Change mowing pattern weekly.

Cutting Height Adjustment

Single-lever adjusts all four wheels simultaneously.

Stop engine and wait for blade to stop.
Pull lever outward and move to desired position (1-6).
Release lever to lock in position.
Test by rolling mower to ensure even height.

Recommended Heights: Position 3 (2 inches) for most grasses. Raise to 4-5 for summer heat. Lower to 1-2 for final fall mowing.

3-in-1 Discharge System

Configure for side discharge, mulching, or bagging.

Side Discharge: Remove bag and mulch plug. Install discharge chute (if removable).
Mulching: Install mulch plug in discharge opening. Ensure bag is removed.
Bagging: Attach rear bagger. Remove mulch plug and discharge chute.

Tip: For best mulching, mow when grass is dry and not too tall. Overlap passes slightly.

Safety Features

Blade control bar: Must be held to keep blade engaged. Releases to stop blade within 3 seconds. Engine kill switch: Stops engine when control bar is released. Safety labels: Read and follow all warnings on mower.

Always: Wear eye protection and sturdy shoes. Clear area of debris before mowing. Mow across slopes, not up/down.

Maintenance & Storage

Regular maintenance ensures long life and safe operation.

After each use: Clean underside of deck. Check blade for damage.

Monthly: Check oil level. Inspect air filter. Lubricate wheel axles.

Seasonal: Sharpen or replace blade. Change oil (every 25 hours or season). Replace spark plug (every 100 hours).

Storage: Run engine dry or add fuel stabilizer. Clean thoroughly. Store in dry place, covered.

CAUTION! Disconnect spark plug wire before any maintenance. Allow engine to cool.

Warranty Information

Murray offers a 2-year limited warranty for residential use. Proof of purchase required. Warranty covers defects in materials/workmanship. Not covered: normal wear, improper maintenance, commercial use, accidental damage. For warranty service, contact Murray at 1-800-800-7310 or visit www.murray.com. Keep this manual and receipt.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Engine won't start	No fuel, stale fuel, clogged air filter	Add fresh gas. Clean/replace air filter. Check spark plug.
Engine runs poorly	Dirty carburetor, old gas	Use fuel stabilizer. Clean carburetor jets.
Uneven cut	Dull blade, uneven tire pressure	Sharpen or balance blade. Check tire pressure.
Vibration	Bent blade, loose parts	Inspect and replace blade if bent. Tighten all bolts.
Bag not filling	Wet grass, clogged deck	Mow when grass is dry. Clean underside of deck.
Wheels not turning	Debris in axles, lack of lubrication	Clean axles. Apply light oil.

Service: For repairs, use authorized service centers. Always use genuine Murray parts.

Support: 1-800-800-7310; www.murray.com