Murray MU-BAT-LM37-KIT Lawn Mower Manual

The Murray MU-BAT-LM37-KIT is a 37-inch battery-powered riding lawn mower featuring a brushless motor, zero-turn radius, dual battery system, LED headlights, adjustable cutting height (1.5-4 inches), mulching/bagging capability, ergonomic seat, cup holder, and battery charge indicator. Powered by two 56V lithium-ion batteries with charger included. Below are key sections for safety, features, assembly, operation, maintenance, and troubleshooting.

1. Features at a Glance 2. Assembly Instructions 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Operating the Mower 7. Battery Charging & Care 8. Maintenance Schedule 9. Storage Guidelines 10. Safety Information 11. Troubleshooting

Features at a Glance

Key components: 37-inch steel cutting deck, Dual 56V lithium-ion batteries, Charger, Zero-turn steering levers, LED headlights, Adjustable seat, Cup holder, Battery indicator.

Feature	Description
Cutting Deck	37-inch steel deck with mulching/bagging capability
Power System	Dual 56V lithium-ion batteries with brushless motor
Steering	Zero-turn radius with dual lever control
Cutting Height	Adjustable from 1.5 to 4 inches (6 positions)
Headlights	LED lights for low-light operation
Seat	Ergonomic high-back seat with adjustable position
Battery Indicator	LCD display showing battery level
Charger	Dual-port fast charger included
Speed Control	Variable speed up to 7 mph
Safety Features	Seat sensor, Blade brake clutch, Parking brake

Assembly Instructions

Unpack and inspect all parts. Assembly requires basic tools.

Install steering levers: Attach to control panel with provided bolts.
Mount seat: Position on frame and secure with four bolts.
Attach cutting deck: Lower deck onto mounting points and secure pins.
Install batteries: Place batteries in compartments, connect terminals.
Connect headlights: Plug wiring harness into control panel.
Install cup holder: Snap into designated slot on dashboard.

WARNING! Mower is heavy; use assistance during assembly. Ensure all bolts are properly tightened.

First-Time Setup

Complete assembly before first use.

Charge batteries: Connect charger to batteries and AC outlet until fully charged (approx. 4 hours).
Adjust cutting height: Set lever to desired position (test on grass).
Check tire pressure: Inflate to 15 PSI (front) and 10 PSI (rear).
Test controls: Practice steering in open area without blades engaged.
Calibrate blades: Ensure all blades are level using leveling tool.

CAUTION! Wear protective equipment during setup. Keep hands and feet away from moving parts.

Specifications

Cutting Width: 37 inches.
Power Source: Dual 56V lithium-ion batteries (10Ah each).
Run Time: Up to 2 acres per charge (varies with conditions).
Charging Time: 4 hours for full charge.
Cutting Height Range: 1.5 - 4 inches (6 positions).
Max Speed: 7 mph forward, 3 mph reverse.
Turning Radius: Zero-turn capability.
Deck Material: 12-gauge steel with anti-scalp rollers.
Weight: 480 lbs (without batteries).
Warranty: 3-year limited warranty on frame, 2-year on batteries.

Controls and Settings

Dashboard: Battery indicator, Headlight switch, Cup holder, Key ignition. Steering: Dual levers for zero-turn control (push forward to go, pull back to reverse). Cutting height: Adjust lever on deck (positions 1-6). Parking brake: Engage lever between seats.

Safety Controls: Seat sensor (stops blades when operator leaves seat), Blade engagement lever (PTO), Parking brake, Key ignition.

Settings: Cutting height adjustment, Speed control via lever pressure, Headlight on/off, Battery indicator shows charge level.

Operating the Mower

Starting procedure and mowing techniques.

Pre-operation check: Battery charge, tire pressure, deck clearance.
Mount mower: Sit firmly in seat, ensure parking brake engaged.
Start engine: Insert key, turn to ON, engage blades with PTO lever.
Release parking brake: Slowly release brake lever.
Steer: Use both levers - push forward to move, differential for turns.
Adjust speed: Control with lever pressure (gentle movements).
Engage blades: Only when moving forward on level ground.
Shut down: Disengage blades, engage parking brake, turn key OFF.

Tip: Mow in straight lines overlapping slightly for even cut. Avoid mowing when grass is wet.

Battery Charging & Care

Proper battery maintenance extends life.

Charging: Use included dual-port charger. Plug into batteries first, then AC outlet.
Storage: Store batteries at room temperature (40-80°F).
Cleaning: Keep terminals clean and dry.
Replacement: Replace both batteries simultaneously for optimal performance.
Winter storage: Charge to 50% if storing over 30 days.

WARNING! Do not expose batteries to water or extreme temperatures. Use only Murray-approved charger.

Maintenance Schedule

Interval	Task
Before each use	Check battery level, tire pressure, blade condition
Every 25 hours	Clean cutting deck, check belt tension
Every 50 hours	Sharpen blades, lubricate moving parts
Every 100 hours	Check wheel bearings, inspect electrical connections
Season end	Full cleaning, battery storage preparation

Blade Sharpening: Remove blades, sharpen at 30-degree angle, balance before reinstalling.

Storage Guidelines

Proper storage prevents damage.

Clean thoroughly: Remove grass clippings from deck and undercarriage.
Battery care: Charge to 50% for long-term storage.
Elevate deck: Store with deck raised to prevent flat spots on tires.
Cover: Use breathable cover in dry location.
Fuel system: Not applicable (battery-powered).

CAUTION! Store in dry, well-ventilated area away from children and pets.

Safety Information

Read all safety instructions before operation.

Wear protective equipment: Safety glasses, hearing protection, sturdy shoes.
Clear mowing area: Remove stones, toys, debris before mowing.
Slope operation: Mow across slopes, not up and down. Max 15-degree slope.
Children and pets: Keep away from mowing area.
Electrical safety: Do not charge batteries in rain or wet conditions.
Transport: Disengage blades, engage parking brake during transport.

EMERGENCY STOP: Release steering levers to stop movement, disengage blades, engage parking brake.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Mower won't start	Dead batteries, seat sensor	Charge batteries; ensure seated properly; check key position.
Uneven cutting	Dull blades, deck not level	Sharpen blades; level deck; check tire pressure.
Reduced run time	Old batteries, thick grass	Replace batteries; mow more frequently; reduce speed.
Steering difficulty	Low tire pressure, linkage	Inflate tires; check steering linkage for obstructions.
Blades not engaging	PTO switch, safety sensor	Check PTO lever; ensure all safety conditions met.
Battery not charging	Faulty charger, connections	Check charger connections; clean battery terminals.

Reset: Turn key OFF, wait 30 seconds, restart. Check battery indicator for error codes.

Service: 1-800-MURRAY-1; www.murray.com