Murray M2265HW Lawn Mower Manual

The Murray M2265HW is a 22-inch, 190cc, self-propelled, high-wheel lawn mower designed for residential use. It features a Briggs & Stratton engine, 3-in-1 side discharge/mulch/bag capability, 6-position cutting height adjustment, single-lever speed control, and a durable steel deck. Below are key sections for safety, features, assembly, operation, maintenance, and troubleshooting.

Features at a Glance

Key components: 190cc Briggs & Stratton engine, 22-inch steel cutting deck, 6-position height adjustment lever, 3-in-1 discharge system, self-propelled drive system, high rear wheels, and a 2.1-bushel grass bag.

Assembly Instructions

Unpack and inspect all parts. Assembly requires basic tools (included).

1. Attach the handle: Align lower handle with deck brackets, secure with provided bolts and washers.
2. Install the grass bag: Attach bag support frame to rear discharge chute, then hook bag onto frame.
3. Install the discharge chute: For side discharge, attach chute to deck opening with wing nut.
4. Attach the height adjustment lever: Connect to deck linkage as per diagram.
5. Add engine oil and fuel: Use SAE 30 detergent oil (approx. 20 oz.) and fresh unleaded gasoline.

WARNING! Do not add fuel indoors or while engine is hot. Ensure all fasteners are tight before operation.

First-Time Operation

Before starting, perform pre-operation checks.

1. Check oil level: Ensure oil is at full mark on dipstick.
2. Add fuel: Fill tank with fresh unleaded gasoline (no more than 1/2 inch below fill neck).
3. Set cutting height: Adjust lever to desired position (start at highest setting for first mow).
4. Select discharge mode: Install appropriate chute or plug for mulching/bagging.
5. Start engine: Set throttle to FAST, pull starter cord firmly.
6. Engage drive: Squeeze blade control lever to handle, then press drive control lever to move.

CAUTION! Clear mowing area of debris. Wear sturdy shoes and eye protection. Never operate without discharge chute or bag properly installed.

Specifications

• Model: Murray M2265HW
• Engine: Briggs & Stratton 190cc, 4-cycle
• Cutting Width: 22 inches
• Cutting Heights: 1.5", 2", 2.5", 3", 3.5", 4"
• Drive: Self-propelled, front-wheel drive
• Wheel Size: Front: 8", Rear: 10" (high wheel)
• Deck Material: Steel
• Discharge: 3-in-1 (side discharge, mulch, bag)
• Bag Capacity: 2.1 bushels
• Weight (approx.): 75 lbs

Controls and Settings

Primary controls located on upper handle.

Handle Controls: Blade control (deadman) lever, Drive control lever, Speed control dial, Height adjustment lever.

Engine Controls: Throttle control (FAST/SLOW/STOP), Choke control (for cold starts), Recoil starter grip.

Settings: Cutting height (lever with 6 positions), Speed (dial adjusts self-propelled pace), Discharge mode (change chute/plug for side discharge, mulch, or bag).

Cutting & Discharge Options

Configure mower for desired lawn finish.

1. Side Discharge: Attach discharge chute. Cuts and expels clippings to side. Best for tall/wet grass.
2. Mulching: Install mulch plug (blocks discharge opening). Cuts clippings finely and returns them to lawn as fertilizer.
3. Bagging: Attach grass bag assembly. Collects clippings for disposal. Ensure bag is empty when half full.

Tip: For best mulching, mow when grass is dry and cut no more than 1/3 of grass height at once.

Maintenance Schedule

Regular maintenance ensures long life and safe operation.

1. Before each use: Check oil level, inspect blade for damage, clear deck of debris.
2. Every 25 hours: Change engine oil (or annually).
3. Every season: Replace air filter, spark plug. Sharpen or replace blade.
4. As needed: Clean underside of deck, check tire pressure, lubricate wheel bearings and height adjustment linkages.
5. Storage: Run engine dry of fuel or add fuel stabilizer.

WARNING! Disconnect spark plug wire before performing any maintenance. Allow engine to cool completely.

Storage Instructions

Prepare mower for off-season storage.

1. Clean thoroughly: Remove all grass and debris from deck, engine, and bag.
2. Fuel management: Either run engine until fuel tank is empty, or add fuel stabilizer to a full tank and run for 2 minutes.
3. Oil: Change oil if due.
4. Spark plug: Remove and check gap; replace if worn.
5. Storage location: Store in a clean, dry place, preferably covered.

CAUTION! Never store mower with fuel in tank in an enclosed area near open flame or pilot lights.

Warranty Information

Murray M2265HW Lawn Mower is covered by a limited warranty. The engine is warranted separately by Briggs & Stratton. For warranty service, contact an authorized Murray service dealer. Proof of purchase is required. This warranty does not cover normal wear items (blades, belts, etc.), damage from misuse, neglect, or improper maintenance. For support, visit www.murray.com or contact 1-800-XXX-XXXX.

Troubleshooting

Service: For repairs not covered here, contact an authorized Murray service center at 1-800-XXX-XXXX or visit www.murray.com.