Murray CRUZ XD MYZ5022000 Lawn Mower Manual

The Murray CRUZ XD MYZ5022000 is a 22-inch self-propelled gas lawn mower featuring a Briggs & Stratton 500cc engine, 3-in-1 mulching/bagging/side-discharge capability, single-lever height adjustment (1.5-4 inches), 2-gallon fuel tank, rear-wheel drive, electric start (with recoil backup), and a durable steel deck. Below are key sections for safety, features, assembly, operation, maintenance, and troubleshooting.

1. Features at a Glance 2. Assembly Instructions 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Operating the Mower 7. Maintenance Schedule 8. Storage Guidelines 9. Safety Information 10. Warranty & Support 11. Troubleshooting

Features at a Glance

Key components: Steel cutting deck, Briggs & Stratton engine, rear bagger, height adjustment lever, drive control bar, electric start key switch.

FeatureDescription
Cutting Width22-inch steel deck
EngineBriggs & Stratton 500cc, 140cc OHV
Drive SystemSelf-propelled rear-wheel drive
Start SystemElectric start with key (recoil backup)
Cutting Options3-in-1: Mulch, Bag, Side Discharge
Height AdjustmentSingle lever, 6 positions (1.5-4 inches)
Fuel Tank2-gallon capacity
Bag Capacity2.5 bushels (rear bagger)
Wheels10-inch rear, 8-inch front
WeightApproximately 85 lbs

Assembly Instructions

Unpack and inspect all parts. Assembly requires basic tools (included).

  1. Attach handle: Align lower handle with deck brackets, secure with bolts and wing nuts.
  2. Install upper handle: Connect to lower handle, secure with provided hardware.
  3. Attach grass bag: Hook bag frame onto rear deck brackets, ensure secure latch.
  4. Install side discharge chute (if not mulching): Attach to discharge opening.
  5. Connect battery (for electric start): Attach red (+) then black (-) cables to battery terminals.
  6. Add oil and fuel: Use SAE 30 oil (20 oz) and unleaded gasoline (87 octane minimum).

WARNING! Wear gloves during assembly. Ensure all bolts are tightened securely before operation.

First-Time Setup

Before first use, complete pre-operation checks.

  1. Check oil level: Ensure dipstick shows full mark.
  2. Fill fuel tank: Use fresh unleaded gasoline only.
  3. Adjust cutting height: Set lever to desired position (recommend 3 inches for first mow).
  4. Test electric start: Insert key, turn to START position (ensure battery is charged).
  5. Engage drive: Squeeze drive control bar to test self-propelled function.
  6. Select cutting mode: Install bagger, mulch plug, or side discharge chute as needed.

CAUTION! Operate mower outdoors only. Keep area clear of children and pets.

Specifications

Controls and Settings

Main controls located on handle. Engine controls on deck.

Handle Controls: Drive control bar (squeeze to engage wheels), Height adjustment lever, Bag latch release, Electric start key switch.

Engine Controls: Throttle lever (FAST/SLOW/STOP), Choke lever (cold starts), Recoil starter handle, Fuel shut-off valve.

Settings: Cutting height (lever positions 1-6), Cutting mode (bag/mulch/side discharge), Drive speed (controlled by bar pressure).

Operating the Mower

Follow these steps for safe operation.

  1. Pre-mow check: Clear lawn of debris, check oil/fuel.
  2. Starting: For electric start, insert key, turn to START. For recoil, set throttle to FAST, pull cord firmly.
  3. Engage blades: Pull blade engagement lever toward handle.
  4. Begin mowing: Squeeze drive control bar to move forward.
  5. Adjust speed: Vary pressure on drive bar.
  6. Empty bag: Stop engine, release bag latch when full.
  7. Shut down: Release drive bar, disengage blades, turn key to OFF.

Tip: Mow in overlapping passes for even cut. Avoid mowing wet grass.

Maintenance Schedule

Regular maintenance ensures optimal performance.

IntervalTask
Before each useCheck oil level, inspect blade, clear deck
Every 25 hoursChange oil, clean/replace air filter
Every 50 hoursReplace spark plug, sharpen blade
SeasonallyLubricate wheels and cables, check battery
As neededReplace drive belt, clean under deck

WARNING! Disconnect spark plug wire before performing any maintenance.

Storage Guidelines

Prepare mower for off-season storage.

  1. Drain fuel: Run engine until tank is empty, or add fuel stabilizer.
  2. Change oil: Replace with fresh SAE 30 oil.
  3. Remove battery: Store in cool, dry place; charge monthly.
  4. Clean deck: Remove grass clippings and debris.
  5. Store indoors: Keep in dry, covered area.

CAUTION! Never store mower with fuel in tank in enclosed spaces.

Safety Information

Read and follow all safety instructions.

DANGER! Gasoline is flammable. Refuel outdoors with engine off and cool.

Warranty & Support

Murray CRUZ XD MYZ5022000 comes with 2-year limited warranty covering defects in materials/workmanship. Warranty does not cover normal wear, misuse, or lack of maintenance. For support, visit www.murray.com or contact 1-800-269-6215. Have model and serial numbers ready (located on deck label).

Troubleshooting

SymptomPossible CauseCorrective Action
Engine won't startEmpty fuel tank, dead battery, clogged air filterAdd fuel, charge/replace battery, clean air filter.
Poor cutting performanceDull blade, low engine speed, wet grassSharpen/replace blade, set throttle to FAST, mow when dry.
Self-propelled not workingDrive belt loose or broken, control cable disconnectedInspect and replace drive belt, reconnect cable.
Excessive vibrationLoose blade, bent blade, debris in deckTighten blade bolt, replace bent blade, clean deck.
Bag not fillingClogged chute, full bag, high grassClear chute, empty bag, mow more frequently.

Reset: For electric start issues, check battery connection and fuse.

Service: 1-800-269-6215; www.murray.com

Murray CRUZ XD MYZ5022000 Lawn Mower Manual © - All Rights Reserved 2025