Murray 7800889 Lawn Mower Manual

The Murray 7800889 is a 22-inch push lawn mower featuring a 190cc Briggs & Stratton engine, 3-in-1 mulching/bagging/side-discharge capability, single-lever height adjustment (6 positions: 1.5-3.75 inches), durable steel deck, easy-fold handle, and rear-wheel drive. Designed for residential lawns up to 1/2 acre. Below are key sections for safety, features, assembly, operation, maintenance, and troubleshooting.

1. Features at a Glance 2. Assembly Instructions 3. First-Time Setup 4. Specifications 5. Controls and Operation 6. Cutting & Discharge Options 8. Maintenance Schedule 9. Storage 10. Safety Information 11. Warranty & Support 12. Troubleshooting

Features at a Glance

Key components: 190cc Briggs & Stratton engine, 22-inch steel cutting deck, Rear bagger with 2.1-bushel capacity, Mulching plug, Side-discharge chute, Single-lever height adjustment, Foldable handle.

FeatureDescription
Engine190cc Briggs & Stratton 4-cycle, overhead valve (OHV)
Cutting Width22 inches
Cutting Height6 positions (1.5" to 3.75")
Drive SystemRear-wheel drive with bail lever control
Deck MaterialPowder-coated steel
Discharge Options3-in-1: Mulch, Bag, Side-discharge
StarterRecoil (pull-start)
Fuel Tank1.1-quart capacity
Wheels8-inch rear, 7-inch front
HandleFoldable for compact storage

Assembly Instructions

Unpack and inspect all parts. Assembly requires adjustable wrench and screwdriver.

  1. Attach Lower Handle: Bolt lower handle sections to deck using provided hardware.
  2. Install Upper Handle: Connect upper handle to lower handle; secure knobs.
  3. Attach Bagging System: Hook rear bagger frame to deck; attach fabric bag.
  4. Install Side-Discharge Chute: Snap chute into opening on right side of deck.
  5. Install Mulching Plug: Insert plug into rear discharge opening when mulching.
  6. Add Engine Oil: Fill with SAE 30 detergent oil (20 oz. capacity).
  7. Add Fuel: Use fresh unleaded gasoline (87 octane minimum).

WARNING! Do not add fuel or oil indoors. Keep away from sparks or flames.

First-Time Setup

Before first mow, complete pre-operation checks.

  1. Check Oil Level: Ensure oil is at full mark on dipstick.
  2. Check Tire Pressure: Inflate to 15 PSI (front) and 20 PSI (rear).
  3. Adjust Cutting Height: Set lever to desired height (middle position recommended).
  4. Test Controls: Ensure drive bail lever engages/disengages smoothly.
  5. Start Engine: Pull starter cord firmly; allow engine to warm up 30 seconds.

CAUTION! Clear mowing area of stones, sticks, and debris before operation.

Specifications

Controls and Operation

Main Controls: Throttle lever (FAST/SLOW/STOP), Drive bail lever, Height adjustment lever, Recoil starter.

Starting Procedure:

  1. Move throttle lever to FAST position.
  2. Prime engine (3-4 presses if cold).
  3. Pull starter cord firmly until engine starts.
  4. Allow 30-second warm-up before mowing.

Stopping: Move throttle lever to STOP. Disconnect spark plug wire for storage.

Height Adjustment: Move single lever to one of 6 positions; ensure all wheels lock at same height.

Cutting & Discharge Options

3-in-1 System: Select mulch, bag, or side-discharge.

  1. Mulching: Install mulching plug; grass clippings cut finely and returned to lawn.
  2. Bagging: Attach rear bagger; collect clippings for disposal.
  3. Side-Discharge: Install side chute; eject clippings to side (for tall/wet grass).

Tip: For best mulching, mow when grass is dry and cut no more than 1/3 of blade height.

Maintenance Schedule

Regular maintenance ensures long life and safe operation.

IntervalTask
Before each useCheck oil level; inspect blade for damage; clear deck of debris
Every 25 hoursChange engine oil; clean/replace air filter; check spark plug
Every seasonSharpen or replace blade; lubricate wheel axles; check tire pressure
StorageDrain fuel or add stabilizer; clean underside of deck; store covered

Blade Sharpening: Disconnect spark plug. Remove blade; sharpen at 30-degree angle; balance before reinstalling.

Storage

Prepare mower for off-season storage.

  1. Drain Fuel: Run engine until tank is empty, OR add fuel stabilizer.
  2. Change Oil: Replace with fresh SAE 30 oil.
  3. Clean Deck: Scrape off grass and debris; wash with water (not pressure washer).
  4. Remove Spark Plug: Add 1 teaspoon oil into cylinder; pull starter slowly to coat.
  5. Fold Handle: Lower handle for compact storage.
  6. Store Indoors: Keep in dry, covered location.

CAUTION! Never store with fuel in tank indoors or near open flame.

Safety Information

Read all safety instructions before operation.

DANGER! Rotating blade can cause severe injury. Always ensure blade has stopped before crossing gravel drives or roads.

Warranty & Support

Limited 2-year warranty for residential use. Proof of purchase required. Warranty does not cover normal wear, misuse, or commercial use. For support, contact Murray Customer Service at 1-800-800-7310 or visit www.murray.com. Have model number (7800889) and serial number ready.

Troubleshooting

SymptomPossible CauseCorrective Action
Engine won't startNo fuel; old gas; clogged air filter; spark plug faultAdd fresh fuel; clean/replace air filter; check spark plug gap (0.030").
Engine runs poorlyDirty carburetor; water in fuel; old oilDrain fuel tank; refill with fresh gas; change oil.
Uneven cuttingDull blade; uneven tire pressure; deck cloggedSharpen blade; inflate tires evenly; clean deck underside.
Vibration/excessive noiseLoose blade; bent blade; debris stuckStop engine; disconnect spark plug; tighten or replace blade.
Drive won't engageDrive cable loose; bail lever not fully pulledAdjust drive cable tension; ensure bail lever is fully engaged.
Grass not baggingBag full; deck wet; grass too tallEmpty bag; mow when dry; raise cutting height for first pass.

For Service: 1-800-800-7310; www.murray.com

Murray 7800889 Lawn Mower Manual © - All Rights Reserved 2025