Murray 465306x8A Lawn Mower Manual

The Murray 465306x8A is a 21-inch push lawn mower featuring a 190cc Briggs & Stratton engine, 3-in-1 cutting system (mulch/bag/side discharge), single-lever height adjustment, durable steel deck, easy-start system, and rear-wheel drive. This manual covers safety, assembly, operation, maintenance, troubleshooting, and specifications to ensure proper and safe use.

1. Features at a Glance 2. Assembly Instructions 3. First-Time Setup 4. Specifications 5. Controls and Operation 6. Cutting System Setup 7. Maintenance Schedule 8. Safety Features 9. Storage & Winterization 10. Warranty Information 11. Troubleshooting

Features at a Glance

Key components: 190cc Briggs & Stratton engine, 21-inch steel cutting deck, 3-in-1 discharge system, single-lever height adjustment, rear-wheel drive, easy-start system, and mulching plug.

Feature	Description
Engine	190cc Briggs & Stratton 4-cycle engine
Cutting Width	21 inches
Cutting System	3-in-1 (Mulch, Bag, Side Discharge)
Height Adjustment	Single-lever, 6 positions (1.5-3.75 inches)
Drive System	Rear-wheel drive
Starting System	Recoil easy-start
Deck Material	Durable steel
Fuel Tank Capacity	1.0 quart
Wheels	8-inch rear, 7-inch front
Weight	Approximately 65 lbs

Assembly Instructions

Unpack all parts and inspect for damage. Assembly requires basic tools (included).

Attach handle: Align lower handle with deck brackets, secure with bolts and wing nuts.
Install upper handle: Connect to lower handle, secure with provided hardware.
Attach wheels: Insert axle through deck brackets, secure wheels with washers and clips.
Install discharge chute: Align with deck opening, secure with bolt and wing nut.
Attach grass bag: Hook bag frame onto deck rear brackets.
Add engine oil: Fill with SAE 30 detergent oil (check dipstick).
Add fuel: Use fresh unleaded gasoline (87 octane minimum).

WARNING! Wear gloves during assembly. Ensure all bolts are tightened securely.

First-Time Setup

Before first use, complete final checks and adjustments.

Check oil level: Ensure oil is at full mark on dipstick.
Check tire pressure: Inflate to 20 PSI (if applicable).
Adjust cutting height: Set lever to desired position (middle setting recommended).
Select discharge mode: Install mulching plug, bag, or side discharge chute.
Test operation: Start engine in clear area, engage blade, check for vibration.

CAUTION! Never operate without proper oil level. Keep hands and feet clear of moving parts.

Specifications

Model: Murray 465306x8A
Engine: 190cc Briggs & Stratton 4-cycle
Cutting Width: 21 inches
Cutting Height: 1.5 to 3.75 inches (6 positions)
Deck Material: Steel
Drive: Rear-wheel
Wheels: 8-inch rear, 7-inch front
Fuel Type: Unleaded gasoline (87 octane minimum)
Oil Type: SAE 30 detergent (20 oz capacity)
Warranty: 2-year limited

Controls and Operation

Handle Controls: Drive control lever, blade engagement lever, height adjustment lever.

Starting Procedure:

Check oil and fuel levels.
Prime engine (3-5 presses on primer bulb).
Set throttle to FAST position.
Pull recoil starter firmly.

Operating: Squeeze drive lever to move forward. Engage blade lever to cut. Release both levers to stop.

Height Adjustment: Move single lever to desired position (1-lowest, 6-highest).

Cutting System Setup

3-in-1 system allows mulching, bagging, or side discharge.

Mulching: Install mulching plug in discharge opening.
Bagging: Remove plug, attach grass bag to rear brackets.
Side Discharge: Remove plug and bag, ensure discharge chute is installed.

Tip: For best mulching, cut dry grass at proper height. Empty bag when 2/3 full.

Maintenance Schedule

Regular maintenance ensures optimal performance and longevity.

Interval	Task
Before each use	Check oil level, inspect blade, clear debris
Every 25 hours	Change engine oil, check air filter
Every 50 hours	Replace air filter, sharpen blade
Every 100 hours	Replace spark plug, check drive system
Season end	Drain fuel, winterize storage

Blade Sharpening: Disconnect spark plug, remove blade, sharpen at 30-degree angle, balance before reinstalling.

Safety Features

Blade Brake Clutch: Stops blade within 3 seconds when handle is released. Safety Key: Prevents unauthorized operation. Discharge Guard: Protects from thrown objects.

Safety Rules: Wear eye/hearing protection. Clear area of debris. Never mow wet grass. Keep children and pets away.

Storage & Winterization

Prepare mower for off-season storage.

Drain fuel: Run engine until tank is empty, or add fuel stabilizer.
Change oil: Replace with fresh oil.
Clean deck: Remove grass clippings and debris.
Remove spark plug: Add teaspoon of oil to cylinder, pull starter slowly.
Store indoors: In dry, covered location.

CAUTION! Never store with fuel in tank for more than 30 days without stabilizer.

Warranty Information

2-year limited warranty from date of purchase. Covers defects in materials/workmanship. Does not cover normal wear, misuse, or lack of maintenance. Proof of purchase required. For warranty service, contact Murray customer service at 1-800-800-7310 or visit www.murray.com.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Engine won't start	No fuel, old gas, clogged filter	Add fresh fuel, check fuel line, clean/replace filter.
Engine runs poorly	Dirty air filter, old spark plug	Clean/replace air filter, replace spark plug.
Uneven cutting	Dull blade, uneven tire pressure	Sharpen blade, inflate tires evenly.
Excessive vibration	Loose blade, bent blade	Tighten blade bolt, replace bent blade.
Won't drive	Drive cable loose, worn belt	Adjust drive cable, replace drive belt.

Service: For technical support: 1-800-800-7310, www.murray.com