Murray 309007x151A Lawn Mower Manual

The Murray 309007x151A is a 21-inch push lawn mower with a 159cc Briggs & Stratton engine, featuring a 3-in-1 mulching, bagging, and side-discharge system, single-lever height adjustment (1.5-4 inches), durable steel deck, easy-start system, and rear-wheel drive. Below are key sections for safety, features, assembly, operation, maintenance, and troubleshooting.

1. Features at a Glance 2. Assembly Instructions 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Operating the Mower 7. Maintenance Schedule 8. Storage Instructions 9. Safety Information 10. Warranty Information 11. Troubleshooting

Features at a Glance

Key components: 159cc Briggs & Stratton engine, 21-inch steel cutting deck, 3-in-1 discharge system, single-lever height adjustment, rear-wheel drive, easy-start system, and grass bag.

FeatureDescription
Engine159cc Briggs & Stratton 4-cycle engine
Cutting Width21 inches
Cutting HeightSingle-lever adjustment (1.5-4 inches)
Discharge OptionsMulch, bag, or side discharge
Drive SystemRear-wheel drive
Deck MaterialDurable steel construction
Starting SystemEasy-start recoil
Fuel Tank0.5-gallon capacity
Wheels8-inch rear, 7-inch front
WeightApproximately 65 lbs

Assembly Instructions

Unpack and inspect all parts. Assembly requires basic tools (included).

  1. Attach handle: Align handle with deck brackets, secure with provided bolts and washers.
  2. Install wheels: Insert axle through deck brackets, secure wheels with retaining clips.
  3. Attach grass bag: Hook bag onto rear discharge chute, secure with clips.
  4. Install discharge chute: Attach side discharge chute if using side-discharge mode.
  5. Add oil and fuel: Fill engine with SAE 30 oil (20 oz), add unleaded gasoline.

WARNING! Wear gloves during assembly. Ensure all bolts are tightened securely.

First-Time Setup

Before first use, complete these steps.

  1. Check oil level: Ensure oil is at full mark on dipstick.
  2. Add fuel: Use fresh unleaded gasoline with minimum 87 octane.
  3. Adjust cutting height: Set lever to desired height (recommend 3 inches for first mow).
  4. Test start: Pull recoil starter slowly until resistance, then briskly to start engine.
  5. Check safety features: Verify blade control lever stops blade within 3 seconds of release.

CAUTION! Operate outdoors only. Keep children and pets away during setup.

Specifications

Controls and Settings

Handle Controls: Blade control lever (must be held to operate), drive control lever, height adjustment lever.

Engine Controls: Throttle control (FAST/SLOW), choke control, primer bulb, recoil starter.

Height Adjustment: Single lever adjusts all four wheels simultaneously. Discharge Selection: Install mulch plug for mulching, bag for collection, or chute for side discharge. Drive Control: Engage rear wheels by squeezing lever against handle.

Operating the Mower

Starting: Set throttle to FAST, press primer 3 times, pull recoil starter. Stopping: Release blade control lever.

  1. Clear area: Remove stones, toys, and debris from lawn.
  2. Select mode: Install appropriate attachment (bag, mulch plug, or side chute).
  3. Adjust height: Set cutting height for grass conditions.
  4. Start engine: Follow starting procedure above.
  5. Engage blade: Hold blade control lever against handle.
  6. Mow pattern: Overlap passes by 2-3 inches for even cut.
  7. Empty bag: Stop engine before emptying grass bag.

Tip: Mow when grass is dry for best results. Avoid mowing in wet conditions.

Maintenance Schedule

Regular maintenance ensures optimal performance and longevity.

  1. Before each use: Check oil level, inspect blade for damage, clear deck of debris.
  2. Every 25 hours: Change engine oil, clean or replace air filter.
  3. Every season: Sharpen or replace blade, check spark plug, lubricate wheels.
  4. Storage: Drain fuel or add stabilizer, clean entire mower, store in dry place.

WARNING! Always disconnect spark plug wire before performing maintenance.

Storage Instructions

Prepare mower for off-season storage.

  1. Clean thoroughly: Remove grass clippings from deck, wheels, and engine.
  2. Fuel management: Run engine until fuel tank is empty OR add fuel stabilizer.
  3. Oil change: Replace oil if due for change.
  4. Blade care: Sharpen blade and apply light oil to prevent rust.
  5. Storage location: Store in dry, covered area away from moisture.

CAUTION! Never store mower with fuel in tank indoors without stabilizer.

Safety Information

Read and understand all safety instructions before operation.

Warranty Information

Murray 309007x151A comes with a 2-year limited warranty covering defects in materials and workmanship. Warranty does not cover normal wear, misuse, or lack of maintenance. For warranty service, contact Murray customer service at 1-800-800-7310 or visit www.murray.com. Keep original receipt as proof of purchase.

Troubleshooting

SymptomPossible CauseCorrective Action
Engine won't startNo fuel, bad spark plug, clogged air filterCheck fuel level; inspect/replace spark plug; clean air filter.
Poor cutting performanceDull blade, low engine speed, wet grassSharpen/replace blade; set throttle to FAST; mow when grass is dry.
Vibration or shakingLoose blade, unbalanced blade, debrisTighten blade bolt; balance blade; clean underside of deck.
Wheels not turningDrive cable disconnected, debris in driveCheck drive cable connection; clear debris from drive mechanism.
Engine stalls during operationClogged fuel filter, dirty carburetorReplace fuel filter; clean carburetor; use fresh fuel.

Service: For technical support, call 1-800-800-7310 or visit www.murray.com

Murray 309007x151A Lawn Mower Manual © - All Rights Reserved 2025