Murray 2691119-00 Lawn Mower Manual

The Murray 2691119-00 is a 21-inch push lawn mower featuring a 140cc Briggs & Stratton engine, 3-in-1 cutting system (mulch/bag/side discharge), single-lever height adjustment, durable steel deck, easy-start system, and rear-wheel drive. This manual covers essential safety instructions, assembly, operation, maintenance, troubleshooting, and storage procedures to ensure optimal performance and longevity of your mower.

Features at a Glance

Key components: 140cc Briggs & Stratton engine, 21-inch steel cutting deck, 3-in-1 cutting system, single-lever height adjustment, rear-wheel drive, easy-start system, and foldable handle.

Assembly Instructions

Unpack all parts and inspect for damage. Assembly requires basic tools (included).

1. Attach handle: Align handle brackets with deck mounts, secure with provided bolts and washers.
2. Install wheels: Slide wheels onto axles, secure with push nuts or washers and cotter pins.
3. Attach grass bag: Connect bagger frame to rear discharge chute, attach collection bag.
4. Install side discharge chute: If using side discharge, attach chute to deck opening.
5. Add oil and fuel: Fill engine with SAE 30 oil (check dipstick). Add fresh unleaded gasoline (87 octane minimum).

WARNING! Always wear gloves during assembly. Ensure all fasteners are tightened securely before operation.

Safety Information

Read all safety instructions before operating. Always wear appropriate protective equipment.

1. Clear mowing area: Remove stones, toys, and debris that could be thrown by blade.
2. Check fuel: Never refuel while engine is hot or running. Allow engine to cool.
3. Start safely: Stand behind mower, ensure drive control is disengaged, then pull starter cord.
4. Operate carefully: Do not mow on steep slopes. Always mow across slopes, not up and down.
5. Keep hands and feet away: Never clear clogs or adjust height while engine is running.

CAUTION! The blade is sharp and can cause serious injury. Disconnect spark plug before performing any maintenance.

Specifications

• Model: Murray 2691119-00
• Engine: Briggs & Stratton 140cc, 4-cycle
• Cutting Width: 21 inches
• Cutting Height: 1.5 - 3.75 inches (6 positions)
• Cutting Options: Mulch, Bag, Side Discharge
• Drive: Rear-wheel drive
• Wheels: 8-inch rear, 7-inch front
• Fuel Capacity: 0.5 gallons
• Oil Capacity: 20 oz (SAE 30)
• Weight: 65 lbs (approx.)
• Warranty: 2-year limited

Controls and Operation

Main controls: Engine throttle, drive control bar, height adjustment lever, and recoil starter.

Starting Procedure:

1. Check oil and fuel levels.
2. Push primer bulb 3 times (cold engine).
3. Set throttle to FAST position.
4. Hold drive control bar to handle.
5. Pull starter cord firmly.

Operation: Release drive control to stop forward motion. Adjust cutting height with single lever. Use bag, mulch, or side discharge as needed.

Stopping: Release drive control, move throttle to STOP, wait for blade to stop completely.

Cutting System Setup

Configure for mulching, bagging, or side discharge.

1. Mulching: Install mulch plug in rear discharge opening. Ensure blade is mulching type.
2. Bagging: Remove mulch plug, attach bagger frame and collection bag.
3. Side Discharge: Install side discharge chute on right side of deck.

Tip: For best mulching results, mow when grass is dry and cut no more than 1/3 of grass height at once.

Maintenance Schedule

Regular maintenance ensures optimal performance and extends mower life.

Engine Care

Proper engine maintenance is critical for reliable operation.

1. Oil Change: Drain oil while engine is warm. Refill with 20 oz SAE 30 detergent oil.
2. Air Filter: Clean foam pre-cleaner in soapy water, dry, and re-oil. Replace paper element if dirty.
3. Spark Plug: Clean and gap to 0.030 inches. Replace annually.
4. Fuel System: Use fresh unleaded gasoline (87 octane min). Add fuel stabilizer for storage.

WARNING! Always disconnect spark plug wire before performing engine maintenance.

Storage Guidelines

Proper storage prevents damage and extends mower life.

1. Clean mower thoroughly, especially under deck.
2. Drain fuel or add fuel stabilizer and run engine for 5 minutes.
3. Change oil and replace air filter if due.
4. Remove spark plug, add 1 oz oil to cylinder, pull starter slowly to distribute, reinstall plug.
5. Store in dry, covered area. Fold handle for compact storage.

CAUTION! Never store mower with fuel in tank indoors or near open flame.

Warranty Information

Murray 2691119-00 comes with a 2-year limited warranty covering defects in materials and workmanship. Warranty does not cover normal wear, misuse, improper maintenance, or commercial use. Proof of purchase required. For warranty service, contact Murray customer service at 1-800-269-6215 or visit www.murray.com. Keep this manual and purchase receipt for warranty claims.

Troubleshooting

Service: For technical support, call 1-800-269-6215 or visit www.murray.com.