Murray 2691109-00 Lawn Mower Manual

The Murray 2691109-00 is a 21-inch push lawn mower with a 140cc Briggs & Stratton engine, featuring a 3-in-1 mulching, bagging, and side-discharge system, single-lever height adjustment, durable steel deck, easy-start technology, and a 2-year limited warranty. Below are key sections for safety, features, assembly, operation, maintenance, and troubleshooting.

1. Features at a Glance 2. Assembly Instructions 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Operating the Mower 7. Maintenance Schedule 8. Storage Guidelines 9. Safety Information 10. Warranty Information 11. Troubleshooting

Features at a Glance

Key components: 140cc Briggs & Stratton engine, 21-inch steel cutting deck, 3-in-1 system, single-lever height adjustment, rear bag, mulching plug, side discharge chute.

FeatureDescription
Engine140cc Briggs & Stratton 500e Series engine
Cutting Width21 inches
Cutting System3-in-1 (mulch, bag, side discharge)
Height AdjustmentSingle-lever, 6 positions (1.25-3.75 inches)
Deck MaterialDurable steel
Wheels8-inch rear, 7-inch front
Starting SystemRecoil start with easy-start technology
Fuel Tank Capacity0.95 quarts (0.9 liters)
Oil Capacity20 oz (0.6 liters)
Warranty2-year limited

Assembly Instructions

Unpack and inspect all parts. Assemble on a flat, clear surface.

  1. Attach handle: Align lower handle with deck brackets, secure with provided bolts and washers.
  2. Install upper handle: Connect to lower handle, tighten wing nuts.
  3. Attach grass bag: Hook bag frame onto rear deck brackets.
  4. Install mulching plug: Insert into rear discharge opening if mulching.
  5. Install side discharge chute: Attach to side port if using side discharge.
  6. Check wheel installation: Ensure all wheels are securely attached and rotate freely.

WARNING! Wear gloves during assembly. Ensure all fasteners are tight before operation.

First-Time Setup

Before first use, complete these steps.

  1. Add engine oil: Remove oil fill cap/dipstick, add 20 oz of SAE 30 detergent oil (check level with dipstick).
  2. Add fuel: Use fresh unleaded gasoline with minimum 87 octane. Do not overfill.
  3. Check tire pressure: Inflate to 20 PSI if necessary.
  4. Adjust cutting height: Set single lever to desired position (middle setting recommended for first mow).
  5. Inspect area: Clear mowing area of stones, sticks, and debris.

CAUTION! Never add oil to gasoline. Always check oil level before starting.

Specifications

Controls and Settings

Handle Controls: Throttle control, drive control bar, height adjustment lever.

Throttle Control: Sets engine speed (FAST for mowing, SLOW for idle). Drive Control Bar: Engage to propel mower (must be held). Height Adjustment Lever: Single lever adjusts all four wheels simultaneously (positions 1-6). Recoil Starter Handle: Pull to start engine. Fuel Shut-Off Valve: Located near fuel tank (turn ON before starting).

Operating the Mower

Starting, mowing, and stopping procedures.

  1. Starting: Move throttle to FAST, prime engine (if equipped), pull recoil starter firmly.
  2. Mowing: Engage drive control bar to propel. Use overlapping passes for even cut.
  3. Stopping: Release drive control bar, move throttle to STOP. Wait for blade to stop completely.
  4. 3-in-1 System: Install bag for collection, mulching plug for recycling, or chute for side discharge.
  5. Height Adjustment: Stop engine, move lever to desired setting.

Tip: Mow when grass is dry for best results. Never remove grass bag or chute while engine is running.

Maintenance Schedule

Regular maintenance ensures long life and optimal performance.

  1. Before each use: Check oil level, inspect blade for damage, clear deck of debris.
  2. Every 25 hours: Change engine oil (or annually).
  3. Every season: Replace air filter, spark plug. Sharpen or replace blade.
  4. As needed: Clean underside of deck, check tire pressure, lubricate wheel bearings.
  5. Storage: Run engine dry or add fuel stabilizer for off-season storage.

WARNING! Disconnect spark plug wire before performing any maintenance.

Storage Guidelines

Prepare mower for storage to prevent damage.

  1. Short-term (under 30 days): Add fuel stabilizer to fresh gas, run engine 5 minutes.
  2. Long-term (over 30 days): Drain fuel tank and carburetor, or use stabilizer in full tank.
  3. Clean: Thoroughly clean deck, wheels, and engine area.
  4. Store: In dry, covered area. Protect from moisture and extreme temperatures.

CAUTION! Never store mower with fuel in tank indoors or near open flame.

Safety Information

Always follow these safety rules to prevent injury.

DANGER! Rotating blade can cause severe injury. Always ensure blade has stopped before crossing gravel drives or roads.

Warranty Information

Murray 2691109-00 comes with a 2-year limited warranty covering defects in materials and workmanship under normal residential use. Warranty does not cover damage from misuse, neglect, commercial use, or improper maintenance. Proof of purchase required. For warranty service, contact Murray customer service at 1-800-269-6215 or visit www.murray.com.

Troubleshooting

SymptomPossible CauseCorrective Action
Engine won't startNo fuel, old gas, spark plugAdd fresh fuel, check spark plug, ensure throttle is set to FAST.
Engine runs poorlyDirty air filter, old fuelReplace air filter, drain and add fresh gasoline.
Uneven cuttingDull blade, uneven tire pressureSharpen or replace blade, inflate all tires to 20 PSI.
Mower vibrates excessivelyDamaged or unbalanced bladeStop engine, inspect blade for damage, replace if necessary.
Won't driveDrive cable not engagedCheck drive control bar connection, adjust cable tension.
Grass not dischargingWet grass, clogged deckMow when grass is dry, stop engine and clear deck.

Service: For repairs not covered under warranty, contact authorized Murray service center. Customer Support: 1-800-269-6215; www.murray.com

Murray 2691109-00 Lawn Mower Manual © - All Rights Reserved 2025