Murray 22406X9A Lawn Mower Manual

The Murray 22406X9A is a 22-inch, 6.5 HP Briggs & Stratton powered push lawn mower with a 3-in-1 mulching, bagging, and side-discharge system, durable steel deck, adjustable cutting height (1.5-3.75 inches), easy-start engine, 2.5 bushel grass bag, and rear-wheel drive. Below are key sections for safety, features, assembly, operation, maintenance, troubleshooting, and specifications.

1. Features at a Glance 2. Assembly Instructions 3. First-Time Setup 4. Specifications 5. Controls and Operation 6. Cutting & Discharge Options 8. Maintenance Schedule 9. Storage Instructions 10. Safety Information 11. Warranty & Support 12. Troubleshooting

Features at a Glance

Key components: 6.5 HP Briggs & Stratton engine, 22-inch steel cutting deck, 3-in-1 discharge system, adjustable cutting height lever, rear-wheel drive, 2.5 bushel grass bag, and easy-start system.

Feature	Description
Engine	6.5 HP Briggs & Stratton, 4-cycle, overhead valve
Cutting Width	22-inch steel deck
Cutting Height	Adjustable from 1.5 to 3.75 inches (6 positions)
Discharge System	3-in-1: Mulch, Bag, Side Discharge
Drive System	Rear-wheel drive
Grass Bag Capacity	2.5 bushels
Wheels	8-inch rear, 7-inch front
Starter	Recoil easy-start system
Fuel Tank	1-quart capacity
Weight	Approximately 65 lbs

Assembly Instructions

Unpack and inspect all parts. Assembly requires basic tools (included).

Attach handle: Insert lower handle into deck brackets, secure with bolts and wing nuts.
Install grass bag: Attach bag support frame to rear discharge chute, hang bag on frame.
Attach discharge chute: For side discharge, secure chute to deck opening.
Install mulching plug: For mulching, insert plug into discharge opening.
Add engine oil: Fill with SAE 30 detergent oil (check dipstick).
Add gasoline: Use fresh unleaded gasoline (no ethanol recommended).

WARNING! Keep hands and feet clear of cutting blade during assembly. Ensure all bolts are tight.

First-Time Setup

Before first use, complete pre-operation checks.

Check oil level: Ensure oil is at full mark on dipstick.
Check fuel: Fill with fresh unleaded gasoline.
Adjust cutting height: Set lever to desired height (middle position recommended).
Select discharge option: Install bag, mulching plug, or side discharge chute.
Test start: Pull recoil starter slowly until resistance, then briskly.

CAUTION! Operate outdoors only. Clear mowing area of debris.

Specifications

Model: Murray 22406X9A
Engine: 6.5 HP Briggs & Stratton, 4-cycle OHV
Cutting Width: 22 inches
Cutting Height: 1.5 - 3.75 inches (6 positions)
Deck Material: Powder-coated steel
Discharge Options: Mulch, Bag, Side Discharge
Bag Capacity: 2.5 bushels
Wheel Size: 8-inch rear, 7-inch front
Fuel Capacity: 1 quart
Oil Capacity: 20 oz (SAE 30)
Weight: 65 lbs (approx.)

Controls and Operation

Handle Controls: Drive control bar (squeeze to engage wheels), height adjustment lever, engine stop lever.

Starting: 1. Check oil and fuel. 2. Push primer bulb 3 times. 3. Set throttle to FAST. 4. Squeeze drive control to handle. 5. Pull recoil starter briskly.

Stopping: Release drive control bar, move throttle to STOP, wait for blade to stop.

Height Adjustment: Move lever to one of 6 positions. Adjust all wheels evenly.

Cutting & Discharge Options

3-in-1 system: Choose before starting.

Mulching: Install mulching plug. Cuts clippings finely returns to lawn.
Bagging: Attach grass bag. Collects clippings for disposal.
Side Discharge: Install discharge chute. Ejects clippings to side.

Tip: For best mulching, mow when grass is dry and not too tall.

Maintenance Schedule

Supports DVD-Video, audio CDs.

Before each use: Check oil, fuel, blade condition, loose parts.
Every 25 hours: Change engine oil (warm engine), check air filter.
Every season: Replace spark plug, sharpen or replace blade, clean deck.
Storage: Drain fuel or add stabilizer, run engine dry.

WARNING! Disconnect spark plug before any maintenance. Wear gloves when handling blade.

Storage Instructions

End-of-season storage steps:

Clean mower thoroughly, removing grass and debris.
Drain fuel tank or add fuel stabilizer and run engine 5 minutes.
Change engine oil.
Remove spark plug, add 1 teaspoon oil, pull starter slowly, reinstall plug.
Store in dry, covered area.

CAUTION! Never store with fuel in tank indoors. Fire hazard.

Safety Information

Read all instructions before use. Always wear sturdy shoes and eye protection. Keep children and pets away. Do not mow wet grass. Clear area of sticks, stones, debris. Stop engine before crossing gravel, roads. Never remove grass bag or unclog chute with engine running. Use extreme caution on slopes.

DANGER! Rotating blade can cause severe injury. Keep hands and feet away.

Warranty & Support

Murray mowers are covered by a limited warranty. For warranty service, contact an authorized service center. Keep receipt as proof of purchase. For parts and support, visit www.murray.com or contact 1-800-269-6215. Manufactured for Briggs & Stratton Power Products.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Engine won't start	No fuel, old gas, clogged filter	Check fuel level; use fresh gas; clean/replace air filter.
Engine runs poorly	Dirty air filter, old fuel	Clean air filter; drain and replace fuel.
Uneven cutting	Dull blade, uneven tire pressure	Sharpen or replace blade; check tire pressure.
Mower vibrates excessively	Loose blade, bent blade	Tighten blade bolt; replace bent blade.
Wheels not driving	Drive cable loose	Adjust drive cable tension per manual.
Grass not discharging	Wet grass, clogged deck	Mow when dry; stop engine and clear clog.

Service: 1-800-269-6215; www.murray.com