Murray 22106X9A Lawn Mower Manual

The Murray 22106X9A is a 21-inch, 6.75 HP Briggs & Stratton powered push lawn mower with a 3-in-1 cutting system (mulch, bag, side discharge), single-lever height adjustment, durable steel deck, and easy-start engine. Below are key sections for safety, features, assembly, operation, maintenance, and troubleshooting.

1. Features at a Glance 2. Assembly Instructions 3. First-Time Setup 4. Specifications 5. Controls and Operation 6. Cutting System Setup 7. Maintenance Schedule 9. Safety Features 10. Care & Storage 11. Warranty Information 12. Troubleshooting

Features at a Glance

Key components: 6.75 HP Briggs & Stratton engine, 21-inch steel cutting deck, 3-in-1 cutting system, single-lever height adjustment, rear bagger, mulch plug, side discharge chute.

Feature	Description
Engine	6.75 HP Briggs & Stratton, 4-cycle, easy-start
Cutting Width	21 inches
Cutting System	3-in-1 (mulch, bag, side discharge)
Height Adjustment	Single-lever, 6 positions (1.5-3.75 inches)
Deck Material	Durable steel construction
Wheels	8-inch rear, 7-inch front
Fuel Tank	1-quart capacity
Starter	Recoil pull-start
Safety Features	Blade control handle, operator presence control
Weight	Approximately 65 lbs

Assembly Instructions

Unpack and inspect all parts. Assembly requires basic tools (included).

Attach handle: Insert lower handle into deck brackets, secure with bolts and wing nuts.
Install wheels: Slide wheels onto axles, secure with push nuts or washers and cotter pins.
Attach bagger: Connect rear bagger frame to deck, install grass bag.
Install mulch plug/side discharge: Choose desired configuration.
Add oil and fuel: Fill engine with SAE 30 oil (check dipstick), add fresh unleaded gasoline.

WARNING! Wear gloves during assembly. Ensure all fasteners are tight before operation.

First-Time Setup

Before first use, complete pre-operation checks.

Check oil level: Ensure oil is at full mark on dipstick.
Add fuel: Use fresh unleaded gasoline only. Do not overfill.
Adjust cutting height: Set single lever to desired position (middle setting recommended).
Test safety controls: Verify blade control handle stops blade when released.
Start engine: Pull recoil starter slowly until resistance, then briskly.

CAUTION! Never add fuel while engine is hot. Operate outdoors only.

Specifications

Model: Murray 22106X9A
Engine: 6.75 HP Briggs & Stratton, 4-cycle
Cutting Width: 21 inches
Cutting Height: 6 positions, 1.5-3.75 inches
Cutting Options: Mulch, Bag, Side Discharge
Deck: 21-inch steel
Wheels: 8-inch rear, 7-inch front
Fuel Capacity: 1 quart
Oil Type: SAE 30 (summer), check manual for alternatives
Weight: 65 lbs (approx.)

Controls and Operation

Blade control handle: Must be held down to keep blade engaged. Single-lever height adjustment: Lift lever, move to desired position. Recoil starter: Pull to start engine.

Starting Procedure:

Check oil and fuel levels.
Move to open, flat area.
Push primer bulb 3 times (if equipped).
Set throttle to FAST position.
Hold blade control handle against handlebar.
Pull recoil starter briskly.

Stopping: Release blade control handle. Move throttle to STOP position.

Cutting System Setup

Configure for mulch, bag, or side discharge.

Mulching: Install mulch plug in rear discharge opening. Ensure side discharge chute is removed.
Bagging: Remove mulch plug. Attach rear bagger frame and grass bag.
Side Discharge: Remove mulch plug and bagger. Install side discharge chute.

Tip: For best mulching, mow when grass is dry and not too tall.

Maintenance Schedule

Regular maintenance ensures long life and safe operation.

Interval	Task
Before each use	Check oil level, inspect blade for damage, clear deck of debris
Every 25 hours	Change engine oil, check air filter, inspect spark plug
Every season	Sharpen or replace blade, clean underside of deck, check wheel bolts
Storage	Drain fuel or add stabilizer, clean entire mower, store in dry place

WARNING! Disconnect spark plug wire before performing any maintenance.

Safety Features

Operator presence control: Blade stops within 3 seconds when handle is released. Blade control handle: Must be held to keep blade engaged. Safety labels: Read and understand all labels on mower.

Care & Storage

Clean after each use. For storage, run engine dry or add fuel stabilizer. Store in cool, dry place.

CAUTION! Never store with fuel in tank indoors. Keep away from open flames.

Warranty Information

Murray mowers are backed by a limited warranty. For details, visit www.murray.com or contact 1-800-800-7310. Keep original receipt for warranty claims.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Engine won't start	No fuel, old fuel, spark plug	Add fresh fuel, check spark plug, ensure throttle/choke set correctly.
Engine runs poorly	Dirty air filter, old fuel	Clean/replace air filter, drain and refill with fresh fuel.
Uneven cut	Dull blade, uneven tire pressure	Sharpen or replace blade, check tire pressure.
Vibration	Loose blade, debris	Tighten blade bolt, clean underside of deck.
Bag not filling	Wet grass, deck clogged	Mow when grass is dry, clean deck interior.

Service: For repairs, contact authorized service center. 1-800-800-7310; www.murray.com